Run air tools offroad
* includes Tire Deflators!
 Shown Bungee corded to the side of Jeep Wrangler |
|
*Tanks must ship empty if mailed.
If you pick them up in person, they'll be
full at no extra charge
All inclusive package comes with everything listed below.
15lb Tank System = $425.00
(you can add a bracket, shelf, or powder coat)
10lb Tank System = $400.00
(you can add a bracket, shelf, or powder coat)
5lb Tank System = $375.00
(you can upgrade or customize your kit anyway you like)
Included: 1 CO2 Tank with 320 CO2 valve.
1 High Pressure, High Flow, minimum Frosting 0 -160 psi dual guage
premium regulator with high SCFM flow.
1 Steel regulator guard to protect those gauges.
25' of high-pressure, 3/8" kink-resistant braided or rubber hose with
Industrial (I) Quick-connect fittings (color may vary)
1 air-tool tire chuck with pressure gauge for rapidly filling your
tires (250 psi capacity or higher)
*When ordering your tank let us know if you want a handle on the
tank (as pictured). The handle takes up a bit of room making it
more difficult to fit into tight spaces, on the shelf or rollbar,
but does make it easier to carry! Also please let us know what
color you would like your tank, and if we can accommodate that we
will! (no charge for spray paint)
*The 10lb tank will fill all 4 of my 35" MT's from 12 psi to 33 psi eight (8) times!! Less if I use air tools or run my water system. I always recommend carrying a 2.5lb spare tank /just in case/ that way you are never caught offguard, unable to air all your tires back up.
#powdercoat We can get your tank powdercoated to match any color for $200 for 99% of most vehicles. (allow 2-3 weeks lead time)
The premium regulators were selected because of their throughput for gas volume. At 90 psi you are getting approximately 9 SCFM
You may notice the bottom part of this regulator "freezing up" after your 2nd or 3rd tire. This is normal. Liquid CO2 is much colder than the freezing temperature of water, and you are just freezing the moisture in the air. **Don't touch it with bare skin** but after a minute it will be thawed all the way back out.
$89.50 if sold separately
$19.95 if sold separatelyThe Offroad Air Buddy Kit includes all of the above, plus 4 brass tire deflators.
- They come with instructions, but just be aware, these generally aren't accurate to the exact PSI. I have mine all set (and locktite'd) to "13" PSI, but if I measure afterwards, I'll get anything from 12-15. That's fine because I'm shooting for 12, so I'll just let out that last 1 psi or so manually. It's still much, much faster than doing it all by hand!
$19.50 set of 4 (buy a second set and
set them to a separate pressure!)ADD-ON ITEMS
Utility Shelf Left (great option for 4-door JK, & LJ)
The Utility Shelf is available in Driver Side (Left) or Passenger Side (Right) configurations and comes complete with a Quick Fist Clamp and hardware. (easy assembly required)
Strong, stable, takes up space normally not utilized in your Jeep
NOTE: **ONLY AVAILABLE without drilling for 2007-2018 JK 4-door, 2004-2006 LJ, and 2018+ JL 4-door Wranglers at this time. This bracket can be used with a 2 door Jeep JK, JL, TJ without rear seats, but it may require drilling one hole for which instructions are not included.**
Sam's Comment: These are
okay. I haven't had a cylinder actually fall out of one of
these, but they do tend to lean, and scoot around on the bottom
flat shelf. The quick Fist should be higher to hold the tank
more in the middle for greater stability. I don't feel 100%
confident with this shelf alone without a couple of bungee cords
as insurance. (See PBI Bracket as un uprade from this)
$65Utility Shelf Right (great option for 4-door JL, JK, & LJ)
NOTE: **ONLY AVAILABLE without drilling for 2007-2018 JK 4-door, 2004-2006 LJ, and 2018+ JL 4-door Wranglers at this time. This bracket can be used with a 2 door Jeep JK, JL, TJ without rear seats, but it may require drilling one hole for which instructions are not included.**
Sam's Comment: These are okay. I haven't had a
cylinder actually fall out of one of these, but they do tend to
lean, and scoot around on the bottom flat shelf. The quick
Fist should be higher to hold the tank more in the middle for
greater stability. I don't feel 100% confident with this
shelf alone without a couple of bungee cords as insurance. (See PBI bracket as an upgrade from this)
$65Roll Bar Bracket (Quick Disconnect)
Great option for 5lb and under. It will work with 10lb tanks. I've seen a lot of you hardcore guys do exactly that, but we're not going to recommend it. Aluminum can break under the stress of an impact, rollover, or crash.
$50"PBI Customs" Bracket
Upgraded Shelf. Completely custom re-designed from
scratch with all of the lessons we learned from the original
shelf. This powder-coated solid steel piece will cup the bottom
of a 10 lb cylinder and place the Quick Fist clamp closer to the middle
for maximum control and security. There is a version for the JK,
the JL, and the XJ should be finalized by the time you see this! (JK version looks slightly different in that it mounts in a different way)
Water Buddy Onboard Water System
Color of the water container may vary, but you're welcome to ask us what we have available! Check out the Water Buddy!
$200
If you're near South Houston, just come on by our facility, Carbonics Inc.
506 Nebraska St, South Houston, TX 77587
We'll be happy to fill your co2 cylinder up while you wait. It will only take a few minutes.
As of March of 2024 the current prices are below. Please call
to make sure nothing has changed!
Your refill of a 20 lb tank will cost $40.67 (incluldes tax and govt fees)
Your refill of a 15 lb tank will cost $29.90 (includes tax and govt fees)
Your refill of a 10 lb tank will cost $28.54
(includes tax and govt fees)
Your refill of a 5 lb tank
will cost $25.24 (includes tax and govt fees)
*prices accurate as of this publication (but always
subject to market fluctuation)
you will receive actual liquid CO2 filled by weight, not just gas!
713-944-7900